feedback
Rate this webpage

Need
Support?


Close Window
IE 6 browser alert

RSS Notification

The version of Internet Explorer you are using does not natively support RSS feeds. If you are unable to upgrade your browser, or do not choose to, you can still access this feature by following the instructions below.

  • Open your RSS feed reader program.
  • To subscribe to the News and New Products Channel, copy and paste the following link into your RSS reader: /PowerSolutions/feed.do
  • To subscribe to only the News Channel, copy and paste the following link into your RSS reader: /PowerSolutions/feed.do?channel=news
  • To subscribe to only the New Products Channel, copy and paste the following link into your RSS reader: /PowerSolutions/feed.do?channel=newProducts

New Products

Amplifiers & Comparators
 

NCS333  Low Power Zero Drift Precision Operational Amplifier

  • Low Offset Voltage of 10 uV max
  • Near-Zero Drift of 0.07 uV/°C max
  • Low Quiescent Current of 17 uA

NCS325  Low Power Zero Drift Precision Operational Amplifier

  • Low Offset Voltage of 50 uV max
  • Near-Zero Drift of 0.25 uV/°C max
  • Low Quiescent Current of 35 uA max
 
 

Interfaces
 

NCN5193  HART Modem

  • Very low current in idle mode
  • Integrated watchdog, DAC and power amplifier
  • Accepts wide range of supply voltages
 
 

Clock & Data Distribution
 

NB3L208K  2.5 V, 3.3 V Differential 1:8 HCSL Fanout Buffer

  • Maximum Input Clock Frequency > 350 MHz
  • 8 HCSL Outputs
  • 80 fs Max Additive RMS Jitter
 
 

Drivers
 

STK672-430AN-E  STK672-432AN-E  STK672-432BN-E  Unipolar 2-Phase Micro-Stepper Motor Drivers

  • Integrated micro-stepping controller
  • Integrated protection against over-current and over-heat (all), and motor terminal open (BN version)
  • Integrated current detection resistors

STK672-630AN-E  STK672-632AN-E  STK672-630CN-E  STK672-640CN-E  Unipolar 2-Phase Stepper Motor Drivers

  • Integrated stepping controller
  • Integrated protection against over-current and over-heat (all); and motor terminal open (CN versions)
  • Integrated current detection resistors

STK531U369A-E  STK531U394A-E  Inverter IPMs for 3-phase Motor Drive, 10 A & 15 A

  • Integrated over current (bus line) protection and pre-drive low voltage protection
  • Bootstrap circuits for upper power supplies (externally set) enable single power supply drive
  • Internal thermistor enables substrate temperature monitoring

STK672-732AN-E  Unipolar 2-Phase Stepper Motor Driver

  • Integrated protection against over-current and over-heat
  • Integrated current detection resistors
  • Integrated common-mode input protection circuit

NCV7518  FLEXMOS Hex Low-Side MOSFET Pre-Driver

  • 16-bit SPI with parity and frame error detection
  • Ratiometric diagnostic references and currents to battery voltage
  • Scalable to load

LC898214XD  Auto Focus (AF) Controller

  • All-in-one closed AF driver, with Hall, EEPROM, controller, driver
  • Integrated 10-bit, 2-input channel A/D converter enables precise auto focus
  • Integrated digital filter and equalizer enable various kinds of actuators

LV8862JA  Single-Phase FAN Motor Driver

  • Single-phase full wave operation by silent PWM drive
  • Speed is controllable by PWM input
  • Synchronous rectification
 
 

IGBTs & FETs
 

NGTB15N60R2FG  600 V, N-Channel IGBT, 14 A

  • High Speed Switching: tf = 75 ns Typ
  • 10 µs Short Circuit Capability
  • High Power Dissipation/Tjmax = 175°C

NDUL09N150C  Power N-Channel MOSFET, 1500 V, 9 A

  • Ultra High Voltage
  • Low On-Resistance of 3.0 Ω
  • High Speed Switching

NGTB03N60R2DT4G  NGTB05N60R2DT4G  NGTB10N60R2DT4G  600 V, N-Channel IGBTs, 4.5 A, 8 A, & 10 A

  • Low Saturation Voltage: VCE(sat) = 1.6 V, High Speed Switching: tf = 70 ns
  • 5 μs Short Circuit Capability
  • High Power Dissipation/Tjmax = 175°C
 
 

Memory
 

CAT25AM02  CAT25M02  Serial CMOS EEPROM, Low Power 2 Mb SPI

  • Supports SPI protocol
  • On chip ECC (Error Correction Code)
  • Hardware and software white protection

LE25U40CMD  Serial Flash Memory, 4 Mb (512K x 8)

  • Read/write operations enabled by single 2.5 V power supply: 2.3 to 3.6 V supply voltage range
  • Small sector erase time: 40 ms (typ), 150 ms (max)
  • Sector size: 4K bytes/small sector, 64K bytes/sector
 
 

Voltage & Current Management
 

LC05132C01MT  Battery Protection Controller with Integrated MOSFET, 1-Cell Lithium-Ion

  • Highly accurate detection voltage/current at Ta = Tj = 25°C, VCC = 3.7 V
  • Low impedance reduces heat dissipation
  • Reset function

NCP392A  Adjustable Front End Overvoltage Protection Controller

  • Protected Vbus output
  • Input voltage spike protection up to 86 V
  • Low Rdson of 34 mΩ

NCP392B  Adjustable Front End Overvoltage Protection Controller

  • Protected Vbus output
  • Input voltage spike protection up to 100 V
  • Low Rdson of 34 mΩ

NCP392C  Adjustable Front End Overvoltage Protection Controller

  • Protected Vbus output & ACOK digital output
  • Input voltage spike protection up to 100 V
  • Low Rdson of 34 mΩ
 
 

Previously Viewed Products
Clear List